Network ApplianceのNS0-502認定試験は全てのIT職員にとって大変重要な試験です。この試験に受かったら、あなたは絶対職場に廃れられることはありません。しかも、昇進と高給も実現できます。NS0-502試験に受かったら成功への鍵を握ったと言った人もいます。これは間違いないです。

JapanCertのIT認証試験問題集は長年のトレーニング経験を持っています。JapanCertにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってNS0-502認証試験に参加する方に対して問題集を研究続けています。

JapanCertのNS0-502問題集は信頼できるものです。当社のスタッフは受験生の皆様が試験で高い点数を取ることを保証できるように、巨大な努力をして皆様に最新版のNS0-502問題集を提供します。

試験番号：NS0-502問題集
試験科目：Network Appliance 「NetApp Certified Implementation Engineer-SAN and Virtualization」

人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。あなた準備しましたか。JapanCertのNS0-502問題集は最高のトレーニング資料です。IT職員としてのあなたは切迫感を感じましたか。JapanCertを選んだら、成功への扉を開きます。

NO.1 Click the Exhibit button.
You see the following error on the storage controller's console or messages file.
What is the most likely cause for this error?
A. portal group misconfiguration
B. iSCSI CHAP misconfiguration
C. iSNS misconfiguration
D. IPsec misconfiguration
Answer: B

NO.2 What would you use to share a data LUN among multiple servers where each server has simultaneous
write access?
A. host-based BootBIOS
B. host-based multipathing
C. host-based volume manager
D. host-based clustered file system
Answer: D

NO.3 Click the Exhibit button.
In the diagram shown, a portset is created on controller 1 with the command: controller1>portset create -f
ntapportset 0b. This portset is bound to the igroup with all the initiators in it.
How many paths can host 1 see to a LUN on controller 1?
A. six paths
B. four paths
C. eight paths
D. two paths
Answer: D

NO.4 A company has a Fibre Channel environment and wants to connect a new host in a remote data
center using 50/125um OM2 multi-mode fiber cable and needs to support 2 Gb speeds.
What is the maximum distance of the cable run supported in this situation?
A. 50/125um OM2 multi-mode fiber cable supports up to 500 meters at 2 Gb.
B. 50/125um OM2 multi-mode fiber cable supports up to 10000 meters at 2 Gb.
C. 50/125um OM2 multi-mode fiber cable supports up to 150 meters at 2 Gb.
D. 50/125um OM2 multi-mode fiber cable supports up to 300 meters at 2 Gb.
Answer: D

NO.5 A customer has a four-node SUN cluster configuration. Each node has two, dual-ported HBAs.
What is the minimum number of igroups that need to be created to map a LUN to the cluster?
A. 1
B. 2
C. 4
D. 8
Answer: A

NO.6 Which utility on Solaris 10 can be used to collect information about firmware and driver versions for a
Qlogic QLAxxx/QLExxxx HBA?
A. EMutil
B. SANutil
C. cfgadmin
D. SANsurfer
E. HBAnywhere
Answer: D

NO.7 Click the Exhibit button.
Based on the diagram shown, what is the appropriate FC switch topology?
A. core-edge
B. full mesh
C. partial mesh
D. partial cascade
Answer: C

NO.8 What are three relevant perfstat counters to check for unaligned I/O that do not fall on the WAFL
boundary? (Choose three.)
A. wp.partial_write
B. vvol_read.io_valid
C. read/write_align_histo.XX
D. read/write_partial_blocks.XX
E. xinode content misses
Answer: ACD

NO.9 Zoning by World Wide Port Name (WWPN) is deployed and a host HBA is replaced.
Which zone change needs to be made?
A. No changes are necessary.
B. The zone configuration should be changed to include the port to which the HBA is connected.
C. The zone configuration should be changed to include the WWPN of the new HBA; the old WWPN will
be automatically dropped.
D. The zone configuration should be changed to include the WWPN of the new HBA and to remove the
WWPN of the old HBA.
Answer: D

NO.10 Click the Exhibit button.
Given the information provided in the diagram, what is the appropriate FC topology?
A. point-to-point
B. switched fabric
C. arbitrated loop
D. ring
Answer: B

NO.11 Which three protocols can be used for communications between a host running SnapDrive for
Windows and the NetApp Storage Controllers? (Choose three.)
A. http:
B. https:
C. ftp:
D. RPC
E. ssh
Answer: ABD

NO.12 An organization currently has a NetApp Fibre Channel block-based solution. With limited budget and
resources, they want to create a new disaster recovery site that utilizes a NetApp solution.
What would the optimal solution include?
A. SnapMover and Fibre Channel at the disaster recovery site for all hosts
B. SnapMirror and iSCSI at the disaster recovery site for all hosts
C. Fibre Channel at both locations using ftp to replicate storage
D. MetroCluster and NAS
Answer: B

NO.13 A 100-GB thinly provisioned LUN is allocated to a Windows host. 100 GB of data is written into the
LUN. The current capacity utilization on the disk array as well as the host is 100%. 50 GB of data is
deleted from the LUN. Space reclaimer has NOT been run.
What is the current capacity utilization on both the host and the disk array?
A. 50% on the host, 100% on the disk array
B. 100% on the host, 50% on the disk array
C. 50% on the host, 50% on the disk array
D. 100% on the host, 100% on the disk array
Answer: A

NO.14 A 200-GB LUN is created in an empty 500-GB volume with the volume guarantee option set to Volume.
LUN reservation is enabled and the fractional reserve is set to 100 and scheduled snapshots are
disabled.
Directly after LUN creation, what is the maximum free space available in the volume?
A. 200 GB
B. 300 GB
C. 400 GB
D. 500 GB
Answer: B

NO.15 Which utility on Windows 2003 and Windows 2008 can be used to collect information about firmware
and driver versions for an Emulex LP1xxxx/LPe1xxx HBA?
A. EMutil
B. SANutil
C. fcp config
D. SANsurfer
E. HBAnywhere
Answer: E

NO.16 Click the Exhibit Button
The table highlights the space management policy that is defined for a particular flexvol, acmevol.
Based on the information provided in the table, which action will the storage controller take when it runs
out of space in the volume?
A. It will try deleting Snapshot copies first to reclaim space before trying to grow the volume.
B. It will grow the volume before deleting Snapshot copies.
C. It will only try deleting Snapshot copies to reclaim space and will not grow the volume.
D. It is irrelevant since fractional_reserve is 0%.
Answer: C

NO.17 Any newly installed system with Data ONTAP 7.3.1 supports which cfmode?
A. dual_fabric only
B. single_image
C. partner
D. mixed
Answer: B

NO.18 Which FC SAN topology provides the best performance and scalability?
A. cascade
B. core-edge
C. full mesh
D. partial mesh
Answer: B

NO.19 Click the Exhibit button.
Based on the diagram shown, what is the appropriate FC switch topology?
A. full mesh
B. core-edge
C. full cascade
D. partial mesh
Answer: B

NO.20 Which utility on Solaris 10 can be used to collect information about firmware and driver versions for an
Emulex LP1xxxx/LPe1xxxx HBA?
A. EMutil
B. SANutil
C. hbainfo
D. SANsurfer
E. HBAnywhere
Answer: E

早くJapanCertのNS0-502問題集を買いに行きましょう。その資料を手に入れたら、異なる人生を取ることができます。運命は自分の手にあることを忘れないでください。